2004 GMC Yukon XL
Mileage
161,551
Service Date
5/28/2024
Services Performed
- REPAIRED MULTIPLE BROKEN WIRES TO THE RIGHT SIDE TAIL LIGHT.
- REPAIR WIRING FOR TRAILER PLUG AND REMOUNT TO BUMPER
- AXLE SHAFT – Remove & Replace – Both – [Independent Suspension. NOTE: For Independent Suspension Type Axles, this operation consists of removal and installation, dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft.]
- SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment (where applicable).]
- SHOCK ABSORBER – Remove & Replace – C1500,K1500 w/Ride Level Control,Both
- TIE ROD &/OR END – Remove & Replace – C1500,K1500 Inner, BOTH
- BALL JOINT – Remove & Replace – K1500,K2500 Lower,Both – [DOES NOT include alignment.]
- CONTROL ARM – Remove & Replace – BOTH UPPER
- IDLER ARM – Remove & Replace – 4WD w/o Skid Plate – [DOES NOT include alignment.]
- (Additional) – PITMAN ARM – Remove & Replace w/Hydraulic Brake Booster add
- PROPELLER SHAFT – Remove & Install or Remove & Replace – One Piece Driveline,To Rear Axle
- Road test vehicle. Check suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber and toe in. Adjust as needed.
- Lubricate chassis at lube points. Change oil and oil filter. Check all fluid levels and top off as necessary. Set tire pressures to recommended specifications. Perform multipoint, non-invasive inspection.
- Remove and replace air filter. Inspect and remove any debris obstructing the air intake system.
KEISHA L. gave our service a 5 star review on 5/28/2024
